How to mount Square Register to your counter

See the new Square Register at http://www.square.com/hardware/register.

Follow step-by-step instructions on mounting Square Register to your counter. Learn how to use the adhesive mount and the screw mount, then choose the right method for you.

Watch our other videos to learn more about Square Register or go to http://www.square.com/register-setup.

TRANSCRIPT

You can mount Square Register to your counter in two ways: with adhesive or with screws.

You’ll need the included mounting plate and tools.

Heads up: Do not attach the mounting plate to Square Register before mounting the plate to a surface—you won’t be able to remove it from Register.

Start by trying out Square Register in different positions on your counter to find the perfect spot.

To mount Square Register with adhesive, use a damp cloth to clean the area where you want to mount Register. Wait for the surface to dry completely. Grab the mounting plate. Remove the backing strips located on the underside of the plate. Position the plate so the raised cleat is on your side of the counter, not the customer’s side. Then, press down firmly for 30 seconds. Wait 30 minutes for the adhesive to set. Place Register onto the mounting plate with the larger screen facing right. Make sure the cleat is positioned in its slot. Turn Register 90 degrees clockwise so it locks in place. That’s it!

If you need to remove the plate, slowly pull the tabs on the adhesive strips until they release. Be careful of the plate as it may spring loose.

To mount Square Register with screws, you need the mounting plate, a drill and the included drill bit, screws, and thumb nuts. Position the mounting plate so the cleat is on your side of the counter, not the customer’s side. Use a pencil to mark the four screw holes on your counter. Use the drill and the included drill bit to make the four holes you’ve marked. Position the mounting plate onto the holes you’ve drilled, and insert a screw into each hole. From the underside of your counter, place a thumb nut onto each screw and tighten until the thumb nut is flush against your counter.

Pro tip: To manage Register’s cables under your counter, drill another hole on the side or in front of the plate.

Place Register onto the mounting plate with the larger screen facing right. Make sure the cleat is positioned in its slot. Turn Register 90 degrees clockwise so it locks in place.

Now you’re ready to start selling. Check out our other videos to learn more about setting up your Square Register or go to http://www.square.com/register-setup.