Singer Serger Threading - Model Ultralock 14u234 Overlocker

Threading a Singer four thread serger / overlocker.
Covering the Singer Ultralock 14u234 and similar models.

This very high quality Singer serger / overlocker, made in Japan, is smooth, quiet and has a differential feed for stretch and gather operations.

Start by making sure the thread mast is positioned properly. Thread the upper looper, then the lower looper and then the needles.

This model can be used as either a four or three thread serger / overlocker.
To use the machine in three thread mode, just remove one needle and its thread.
Tools required - Tweezers and scissors or snips.

Index:
0:00 - Introduction
0:54 - Preparing and threading the thread mast
2:19 - Threading main guide bar
3:34 - Threading tension disks
4:53 - Colour coding
5:40 - Upper looper threading
9:07 - Lower looper threading
13:13 - Needle threading
16:35 - Preparing for sewing - chaining off
17:19 - Serging / overlocking
17:49 - Conclusion

Troubleshooting:
Make sure to have good needles installed. If you're unsure, replace them with brand new ones.
Check the blades are cutting well. Use several strands of thread and put them under the top blade and turn the hand wheel until the blade comes down and the threads should be cut cleanly. If not, the blades will need sharpening.
Double check the treading and check the tensions.

www.institches.co.nz
www.patreon.com/sewingmachines